exhaust options - R1150RA

Topics related to the ownership, maintenance, equipping, operation, and riding of the R1150R.

Moderator: Moderators

joyonroy
Basic User
Posts: 10
Joined: Mon May 12, 2008 9:04 am

exhaust options - R1150RA

Post by joyonroy »

I'm thinking of adding a Leo Vince SBK Evo II Carbon Slip On (#6338) exhaust to my 2002 R1150RA.

Does anyone have any advice on this add? a good idea? better alternatives?
User avatar
MattPie
Lifer
Posts: 422
Joined: Sun Mar 20, 2005 1:09 pm
Donating Member #: 0
Location: Valley Forge, PA

Re: exhaust options - R1150RA

Post by MattPie »

Several people here have run their bike without any muffler. The catalytic converter actually does a pretty good job of muffling the exhaust, and is enough of a bottle-neck that fuel injection can adjust far enough to have the bike run right. Might as well give it a try, since it's only two bolts and a few minutes to take it off. Most of the people have added a stubby pipe (from a car parts store) to make the end of the cat look a little prettier.
Go Sabres!
User avatar
shake1150
Lifer
Posts: 91
Joined: Fri May 18, 2007 8:14 am
Donating Member #: 0
Location: Toronto, Canada

Re: exhaust options - R1150RA

Post by shake1150 »

Staintune muffler & collector box. great fit & finish... almost looks stock. great sound too.
Don't wrestle with a pig. Win or lose, you still get dirty.
markg
Basic User
Posts: 50
Joined: Mon Oct 29, 2007 4:08 pm
Donating Member #: 0
Location: San Clemente, CA.

Re: exhaust options - R1150RA

Post by markg »

Be sure to dump the cat converter first. For the change in hp read the two links below. I have a sebring Y pipe with stock cans. An improvement in smoothness, power, weight difference I can feel, and most importantly, a major heat source under the gear box is gone.

Try a Y pipe first, then add a cannister if you still feel the need.

http://www.moto-one.com.au/performance/r1150rgs.html
http://www.moto-one.com.au/performance/ ... ntune.html
User avatar
jeremell
Basic User
Posts: 46
Joined: Wed May 16, 2007 8:08 pm
Donating Member #: 0
Location: Madison, WI

Re: exhaust options - R1150RA

Post by jeremell »

I like my ZTech titanium system with cat removed.

http://www.ascycles.com/detail.aspx?ID=1484
beemerboy
Basic User
Posts: 69
Joined: Mon May 05, 2008 9:10 pm
Donating Member #: 0
Location: Waterford, Wisconsin

Re: exhaust options - R1150RA

Post by beemerboy »

So anyways I took the whole pull the muffler off idea and did that tonite.
It isnt bad, its not as bad ass sounding as i had hoped but it does make it louder and a little more bass sounding.

Though i did notice when you twist that throttle it tends to torque a little bit more to the side than it used to.

Just wondering if anyone else has noticed this.
def38
Basic User
Posts: 201
Joined: Sat May 12, 2007 9:55 pm
Donating Member #: 0
Location: County Line, Alabama

Re: exhaust options - R1150RA

Post by def38 »

beemerboy wrote:So anyways I took the whole pull the muffler off idea and did that tonite.
It isnt bad, its not as bad ass sounding as i had hoped but it does make it louder and a little more bass sounding.

Though i did notice when you twist that throttle it tends to torque a little bit more to the side than it used to.

Just wondering if anyone else has noticed this.
About all you have accomplished is to make the engine run a bit leaner. The result will be more engine heat especially on the exhaust side.
Dennis....quit worrying about your oil..go ride
DJ Downunder
Honorary Lifer
Posts: 4776
Joined: Sun Mar 20, 2005 3:26 pm
Donating Member #: 0
Location: Melbourne

Re: exhaust options - R1150RA

Post by DJ Downunder »

def38 wrote:
beemerboy wrote:So anyways I took the whole pull the muffler off idea and did that tonite.
It isnt bad, its not as bad ass sounding as i had hoped but it does make it louder and a little more bass sounding.

Though i did notice when you twist that throttle it tends to torque a little bit more to the side than it used to.

Just wondering if anyone else has noticed this.
About all you have accomplished is to make the engine run a bit leaner. The result will be more engine heat especially on the exhaust side.
How so?....Just wondering.

DJ
beemerboy
Basic User
Posts: 69
Joined: Mon May 05, 2008 9:10 pm
Donating Member #: 0
Location: Waterford, Wisconsin

Re: exhaust options - R1150RA

Post by beemerboy »

So am I hurting the bike? Because i love my bike and dont want to do any harm to it.
def38
Basic User
Posts: 201
Joined: Sat May 12, 2007 9:55 pm
Donating Member #: 0
Location: County Line, Alabama

Re: exhaust options - R1150RA

Post by def38 »

Running leaner produces more engine heat which is the enemy of the air/oil cooled boxer. The stock exhaust on the bike was carefully designed to provide the correct pressure and hence the correct mixture and driveability. Also, the ECU map is designed against the stock system. By removing the pipes, CAT and O2 sensor, you have modified the engine stoichiometry. Yes, damage could result from overheating or other fueling issues.

The boxer motor does not respond well to exhaust modifications without adding chips and other components. Usually the result is 1-3 HP gain, a bit more noise and reduced gas mileage. The costs for such modifications will usually reach $1000.00 or higher.

You are better off buying your wife (or GF) some flowers.
Dennis....quit worrying about your oil..go ride
duke
Lifer
Posts: 353
Joined: Sun Jan 08, 2006 12:41 pm
Donating Member #: 568
Location: And the bike is long dead :-(

Re: exhaust options - R1150RA

Post by duke »

def38 wrote:... You are better off buying your wife (or GF) some flowers.
That would be a lot of flowers ... try some jewellery too :mrgreen:
DJ Downunder wrote:How so?....Just wondering.
Broadly speaking in effect you increase the amount of air going through the engine.
You will have similar effect if you add some free-flow air filter.

From all the CAT replacements - better get a Y-piece with thread to be able to reinstall the Lambda sensor.
That would keep the engine partially happy.
Also - consider adding something like Techlusion and adjust the lot.
For best result - get it on a Dyno so they can get your air/fuel mixture right.
def38 wrote:Usually the result is 1-3 HP gain
Well - I would not do something like that for HP increase. Too expensive.
If I was chasing raw power and speed - I will sell the Rockster and buy a Honda Fireblade.
More like - to get a "fruity" exhaust note.
beemerboy
Basic User
Posts: 69
Joined: Mon May 05, 2008 9:10 pm
Donating Member #: 0
Location: Waterford, Wisconsin

Re: exhaust options - R1150RA

Post by beemerboy »

well darn it anyway, looks like im putting the pipe back on.
if anyone has any other cool ideas let me know

I unfortunalty dont have a wife....or a gf...she left me........ :(
what ever happened to women that actually wanted a nice guy
beemerboy
Basic User
Posts: 69
Joined: Mon May 05, 2008 9:10 pm
Donating Member #: 0
Location: Waterford, Wisconsin

Re: exhaust options - R1150RA

Post by beemerboy »

I kept the cat on there all i took off was the actual muffler so now my rear wheel is exposed.
So if this is still a problem let me know
DJ Downunder
Honorary Lifer
Posts: 4776
Joined: Sun Mar 20, 2005 3:26 pm
Donating Member #: 0
Location: Melbourne

Re: exhaust options - R1150RA

Post by DJ Downunder »

beemerboy wrote:I kept the cat on there all i took off was the actual muffler so now my rear wheel is exposed.
So if this is still a problem let me know
I've been running my bike like that for 6 yrs now (70,000 klms)...and it doesn't run lean..(I've had it checked).

As long as you do not remove the cat..it'll be ok.

It's not much different to putting a sports type straight through muffler on the cat...Just cheaper and lighter.

DJ
Byrdguy
Basic User
Posts: 183
Joined: Sat Apr 14, 2007 10:20 am
Donating Member #: 0
Location: FL.Panhandle

Re: exhaust options - R1150RA

Post by Byrdguy »

I've got a Remus Y pipe and slipon on my 02 with a high flow air filter and intake snorkel and a techlusion fuel tuner. The bike runs and sounds great. It dynoed at 86 RWHP with 100 ft/lb of torque.
fj_pastor
Basic User
Posts: 79
Joined: Sun Jan 21, 2007 4:24 pm

Re: exhaust options - R1150RA

Post by fj_pastor »

+1 to the DJDownUnder modification

The motor feels great without the stock can (keeping the cat)


Thanks DJ :D :D :D :D
duke
Lifer
Posts: 353
Joined: Sun Jan 08, 2006 12:41 pm
Donating Member #: 568
Location: And the bike is long dead :-(

Re: exhaust options - R1150RA

Post by duke »

Byrdguy wrote:I've got a Remus Y pipe and slipon on my 02 with a high flow air filter and intake snorkel and a techlusion fuel tuner.

That's my boy! As soon as I win the lottery I am going for the same set-up! :mrgreen:
DJ Downunder
Honorary Lifer
Posts: 4776
Joined: Sun Mar 20, 2005 3:26 pm
Donating Member #: 0
Location: Melbourne

Re: exhaust options - R1150RA

Post by DJ Downunder »

duke wrote:
Byrdguy wrote:I've got a Remus Y pipe and slipon on my 02 with a high flow air filter and intake snorkel and a techlusion fuel tuner.

That's my boy! As soon as I win the lottery I am going for the same set-up! :mrgreen:
Me too!... :biggrin:

DJ
def38
Basic User
Posts: 201
Joined: Sat May 12, 2007 9:55 pm
Donating Member #: 0
Location: County Line, Alabama

Re: exhaust options - R1150RA

Post by def38 »

So, you all want more performance from your boxers do you? Well, loose 20 lbs. and attend an advanced riding school.

If it is noise you want, the boxer is the wrong bike for you...head to your H-D store. :badgrin:
Dennis....quit worrying about your oil..go ride
Byrdguy
Basic User
Posts: 183
Joined: Sat Apr 14, 2007 10:20 am
Donating Member #: 0
Location: FL.Panhandle

Re: exhaust options - R1150RA

Post by Byrdguy »

I've got an HD too. Has slipons, high flow A/C and power Commander. It runs like a scalded... well, it's faster than a stock one anyway.
Post Reply