ROCKSTER PUNCTURE, LONDON, 2 MAY

This section is dedicated to the new Rockster version of the R1150R.

Moderator: Moderators

Post Reply
chipko
Basic User
Posts: 26
Joined: Thu Jun 01, 2006 7:49 am
Donating Member #: 0
Location: London

ROCKSTER PUNCTURE, LONDON, 2 MAY

Post by chipko »

From a four inch masonry nail. :evil:

A massive thank you to Riceburner 8) who appeared as if by magic (like the shopkeeper from Mr Benn) and lent me his Innovations puncture kit. All went well until we'd re-inflated the tyre and noticed that air was still coming out: not through the repaired hole in the tread which seemed to be holding fine, but through the hole in the sidewall where the nail had gone through that as well (the nail was bent at right angles). :roll:

Thank you too to the cyclist that stopped and offered me use of his bicycle pump while I was sulking at the roadside, and the Africa Twin rider who stopped to ask if I was OK.

BMW sent a recovery van which dropped me off at the train station and the bike off at Motorrad Park Lane in Battersea. I'm waiting for them to tell me how much a new tyre is going to cost. Anyone want a Dunlop fender for their fishing boat? Never raced or rallied ...

Lessons learned:

+ :oops: the place for my own puncture kit is under the seat, not in the hall drawer at home
+ :oops: the place for the BMW emergency call-out card is (ditto) or in my wallet
+ :oops: the place for the BMW emergency call-out number and the data on the card is in my mobile phone, as a back-up

Duh. But I did look so cool going home on the train in leathers and a hi-viz jacket. And the recovery driver did say it was the first Ed 80 he'd seen.

Ricey - please PM me your phone no, address at home or at work or let's meet up at the Shell station just up the road or at Box Hill (Visordown meet?) and I'll give you a gas cannister or the means to replace same - let me know?

chipko
Not so much life in the fast lane
... as life in the oncoming traffic
DJ Downunder
Honorary Lifer
Posts: 4776
Joined: Sun Mar 20, 2005 3:26 pm
Donating Member #: 0
Location: Melbourne

Post by DJ Downunder »

Good on-ya Riceburner.. =D>

chipko...just a thought...a couple of short metal screws might have got you through.

I carry some...Just screw them into the hole/holes..fill with air and carefully ride home or to a bike shop to have it repaired/replaced.

Sounds suss I know..but it does work.

DJ
User avatar
riceburner
Basic User
Posts: 3809
Joined: Fri Mar 18, 2005 7:54 am
Donating Member #: 0
Location: Hiding in your blind spot....
Contact:

Post by riceburner »

DJ Downunder wrote:Good on-ya Riceburner.. =D>

chipko...just a thought...a couple of short metal screws might have got you through.

I carry some...Just screw them into the hole/holes..fill with air and carefully ride home or to a bike shop to have it repaired/replaced.

Sounds suss I know..but it does work.

DJ
DJ - I doubt that'd work in a sidewall unfortunately - there's not much there to support the screws.

Chipko - don't worry about it, just buy me a beer or something next time. :D
Non quod, sed quomodo.

A Rockster Life
Post Reply