BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

looking to remove the abs and servo off of a 2002 1150r and take brakes back to normal, brake lines are all original so hoping to replace them with s/s braided ones, anybody know the best place to buy the bits to do this ? uk based suppliers would be best to save on shipping costs....... read a few of the posts on this and although not an engineer seems to be something i could probably do myself, anybody got any views on that ....... thanks.

You can review my write-up in the Rockster section, but - considering the simplicity of the job for your Roadster- suggest instead that you read through the following:

http://www.boxertrix.com/phpBB2/viewtopic.php?t=13118

While you're messing with the plumbing, the upgrade to better brake lines is strongly recommended. Even used steel braided OE brake lines from later model year R1150R bikes would be an improvement over your 2002 lines.

thanks mr sweatmark, going to give it a go next week , will post results !

Hi bubsees ! Try here: http://helperformance.com/store/index.php?cPath=145_18

does anyone in or around nyc/tri-state area want to remove abs?
i'm not very mechanically inclined, but i'm terrific at moral support.