BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

When I bought my R, I dutifully followed the manual's advice about not letting the revs rise (much) above 4000 for the break-in period. Then I noted plenty of ride-it-like-you-stole-it advice on this board, and because I wanted the valves to seat correctly, etc., I dutifully road pushed the bike hard. Now I find that I shift in the 5000-5500 range most of the time and ride in the 4000-4500 range. I like the sense of readily available torque. With 11,000 miles on the clock, the oil consumption is slowing down, and the bike has always run great. I'm just seeking confirmation that I'm not riding it harder than is good for it. Any feedback appreciated.

You're not doing it any harm. I have ridden all my Beemers (since 1976) between 4-7k rpm and have clocked over 600k miles with zero problems. I know a lot of riders who have done the same with no problems. Have fun!

You're doing the right thing..IMO...and it's better to slightly over rev than under rev (lug it)...but these bikes do like low revs.

With 11,000 miles up now you should not worry about any run-in stuff...just ride normaly..and have fun..

DJ