Page 1 of 1
R1150R Front Fender
Posted: Sun Mar 26, 2006 10:07 pm
by revperry
Will a front fender from a Rockster bolt up to a R1150R front end without a lot of hassle?
rx fr fender
Posted: Sun Mar 26, 2006 10:22 pm
by rivi7777
hassle, yes...
rockster shares the r1100s front end. you can bolt on a KRS, RRS front fender to the Roadster
Posted: Sun Mar 26, 2006 10:26 pm
by DJ Downunder
Will a front fender from a Rockster bolt up to a R1150R front end without a lot of hassle?
My answer is..No.
It's a different fork and different mounts.
I have seen a Roadster beak mounted on a Rockster...with a bit of mucking around.
I've never seen a Rockster fender on a Roadster.
I would like to see it done...there must be a way.
DJ
check this out...something different
Posted: Wed Mar 29, 2006 2:44 am
by bimrluvr
Re: rx fr fender
Posted: Wed Mar 29, 2006 6:08 am
by leno
rivi777 wrote:hassle, yes...
rockster shares the r1100s front end. you can bolt on a KRS, RRS front fender to the Roadster
The rockster does share the front end with the S but the Roadster does not and so you can not just swap mudgards. I think that the RS front will however fit.
fenders
Posted: Wed Mar 29, 2006 10:38 pm
by rivi7777
I think that the RS front will however fit.
It will. Here's the RRS front fender with LT inner mudguard on my RR. Both the KRS/RRS fenders, and LT inner mudguard are easily installed on the RR and are direct bolt ons.
http://r1150r.smugmug.com/photos/21432411-L.jpg
BTW, I still have this setup (minus the LT mudguard) after having sold my Roadster. PM if interested...
